Elo TouchSystems 2201L Specifiche Scaricare il pdf (Pagina 97)

Command Descriptions 87

3 2400

4 4800

5 9600

6 19200

7 38400

Serial controllers are shipped jumpered for 9600 baud. The values for the S1 byte

correspond to those used in the Parameter command (page 95). Not all of the

above baud rates are available through jumper settings.

The S2 byte is an ASCII '0' if serial Hardware Handshaking is disabled by the J3

jumper on power-on. It is a '1' if Hardware Handshaking is enabled. Serial

controllers are shipped jumpered for Hardware Handshaking enabled (J3 not

installed).

The S3 byte is an ASCII '0' if the SmartSet ASCII Mode is selected on power-on

by the J2 jumper. A '1' indicates the SmartSet Binary Mode. Serial controllers are

shipped jumpered for Binary Mode (J2 not installed).

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 138 139

Nessun commento

Elo TouchSystems 2201L Specifiche Pagina 97